Large-scale circulating fluidized bed boilers, gas boilers, biomass boilers, waste heat boilers for waste, hazardous waste, non-ferrous metals, CDQ and other waste heat boilers, R&D and manufacturer of new intelligent control autoclaves
Use process of steam generator
Home » service support » Boiler knowledge » Boiler knowledge » Use process of steam generator

Use process of steam generator

Views: 1478     Author: Site Editor     Publish Time: 2023-02-20      Origin: Site


Jiangsu Sifang Boiler Co., Ltd. was established in 1998, and is the first ASME accredited special equipment manufacturing enterprise of China Special Equipment Inspection and Research Institute. Through technological and innovative development, our company has become the leading boiler industry in China.


Before using the steam generator equipment, in order to ensure the working state of the equipment, in addition to paying attention to the quality of the equipment, it is also necessary to master the correct operation methods and precautions.

1. Before using the steam generator, carefully read the boiler operation manual to ensure correct use and maintenance of the equipment. Check the water tank to ensure that there is no debris in the water tank, otherwise the water pump will be damaged or the check valve will be stuck.

2. Before daily operation, the steam valve shall be opened, and then the blowdown valve shall be opened until the water and dirt in the boiler are completely discharged.

3. During the installation of steam generator pipeline, it is necessary to consider the factors such as preventing the heated object from being poured backwards and discharging the condensed water in the pipeline.

4. Close the filter valve and the steam safety valve remains open. Turn on the main power switch of the air conditioner evaporator. At this time, a low water alarm will be sent out, and the water inlet valve will operate to replenish water for the air conditioner evaporator until the water level in the boiler is higher than the minimum water level.

5. When the evaporator enters the normal working state, the steam valve can be closed, and the evaporator starts to increase pressure slowly. When the steam pressure rises to the set pressure, the heating automatically stops. At this time, steam can be used normally.

6. The evaporator shall be discharged at least once a day. After the completion of each day, it shall be discharged when the power supply is disconnected for 15 minutes and the pressure drops by 0.05Mpa. Pay attention to prevent scalding when discharging.

7. Check twice a day whether the time for water treatment is consistent with the actual time, otherwise it should be adjusted. Once the time for adding salt in the salt tank is set, salt must be added in strict accordance with the regulations.


WNSL燃油燃气锅炉02


The above is Jiangsu Sifang Clean Energy Equipment Manufacturing's answer to this question. If you have any questions about other boiler related issues, please consult Jiangsu Sifang Clean Energy Equipment Manufacturing's online customer service or call 0516-85871846 or 0516-85532705. Jiangsu Sifang Clean Energy Equipment Manufacturing's professional technicians will answer your questions in time.


Integrate high-end technology to create high-quality boilers

Product Center

Quick Links

Services

Contact us
+86 516 85532690
Huarun Industrial Park, Xuzhou Huaihai International Port District, Xuzhou City, Jiangsu Province, China
Whatsapp: +86 19805005735
E-mail: xxb@jssfgl.com
Copyright 2023 Jiangsu Sifang Clean Energy Equipment Manufacturing Co.,Ltd | Sitemap    苏ICP备14011720号-1
Technical Support: Leadong